Ways to move a grand piano

Pianos routinely make movers annual list of products that are most often harmed. Grand pianos are especially troublesome. Practicing the following treatments for dismantling, padding and loading grand pianos will prevent damage, lower claims cost, and enhance consumer satisfaction.

1) At least 3 individuals are needed to deal with an infant grand piano. If the child grand piano requires to go up or down stairs or if a full or concert grand piano needs to be transported, a minimum of four people are needed.

2) Always complete a comprehensive and accurate stock. It might be more effective or essential to utilize a visual inventory to effectively explain and show pre-existing damage.

3) As various parts are disassembled, please location all hardware in an effectively labeled parts bag and after that position the parts bag in a "Components Box".

4) Remove the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a clean furnishings pad.

5) Detach the lid by getting rid of the hinge pins. Wrap the lid in a clean furnishings pad.

6) Remove the prop that holds the cover open and cover it in a clean furnishings pad. The prop has a hinge pin and remains in two pieces.

7) Remove the pedal assembly and wrap it in a tidy furniture pad. The braces at the rear of the assembly rest in slots at each end. When eliminating the screws, please take care not to drop the braces. In addition, please be specifically careful with the push-rods so that they will not get bent. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the proper number on each rod. Note: If masking tape is not available, please usage properly labeled parts bags for this purpose. When reassembling at destination, please make sure to put the rods in the right order so that the pedals will work properly.

8) Pad the piano by placing a clean rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to avoid it from tumbling open while you deal with the piano. Cover the top of the piano with 2 clean furniture pads, nicely folded around the keyboard. Usage rubber bands to secure the pads. Keep in mind: Please ensure that the surface of the piano is dust-free prior to padding it. Padding an extremely polished surface area that is dirty may cause fine scratches, specifically on a black lacquer finish.

9) Position a piano board and attach the straps so that it is ready to get the piano. The raised brace on the piano board must be at the keyboard end of the piano.

10) Eliminate the left front leg by placing one person underneath the piano at the left end of the keyboard. Be sure to have two people lifting the corner of the piano while the third person eliminates the leg. Keep in mind: Please be sure to keep in mind which legs were gotten rid of from which positions since some pianos have legs that are not interchangeable.

11) Place the piano on the piano board by lowering the "leg-less" end onto the board. Please be sure to lift the whole piano somewhat while finishing this maneuver to avoid unnecessary pressure on the remaining, attached legs as the piano tips. Raise the piano to an upright position this contact form on the board. Keep in mind: Please guarantee that the soundboard is safe and secure prior to lifting. Be sure that the piano is focused comfortably against the brace at the end of the piano board. Note: Never ever leave the piano ignored. Always have at least someone holding the piano constant at all times.

12) Remove the two staying legs and wrap them in tidy furniture pads. These legs are kept in location by a "essential and slot" plan. To get rid of the leg, slide it inward toward the center of the piano till it comes out of the slot.

13) Secure the piano to the piano board by bringing completions of the straps together and attaching them. Place folded burlap pads over the furnishings pads however under the straps to offer extra protection to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, connect the loose ends of the two straps together.

14) To move the piano over a flat, level surface, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, utilize the piano board as a skid. After sufficiently padding the stairs for security versus residence damage, put the keyboard end of the piano towards the bottom of the stairs. Connect a bulge strap to the top end of the piano board to prevent the piano from slipping.

16) To load the piano, leave it on the piano board and place it in a tier as the first base item with the keyboard facing the wall of the preceding tier. The very best location to pack the cushioned cover is in between the piano and the preceding tier or in between the piano read this article and the wall.

Although grand pianos represent a substantial obstacle, they can be moved without damage by utilizing sound judgment and practicing the treatments listed above.

Leave a Reply

Your email address will not be published. Required fields are marked *